110V Electrical Power Line IEC Inlet Filter

Basic Info

Operating Frequency: 50/60Hz

Climatic Category(IEC 60068-1): 25/085/21(-25℃ /+85℃ Damp Heat Test For 21 Days)

Rated Voltage: 110/250VAC

Rated Current: 1-16A@40℃

Test Voltage: 1500VDC, 3S(line-line); 1500VAC, 3S(line-ground)

Additional Info

Packaging: Carton

Productivity: 500,000pcs annually

Brand: FILTEMC

Transportation: Ocean,Air

Place of Origin: Jinan

Certificate: ISO9001, CE, UL, TUV, RoHS

HS Code: 8548900001

Port: Qingdao,Tianjin,Beijing

Product Description

An IEC Inlet Filter will suppress the interference created by other equipment and the interference of themodule or system itself, with the desired result being improvement to the immunity from EMI signals in the surrounding setting. 

Electrical Filters can be found both in plastic as well as metal housings, in stand-alone, desktop or module configurations.

Features and Beneifits of RFI Filter for Radio:

• Specially designed for standard IEC connector, fast and simple installation, highly cost effective.  
• FT110I series are general purpose one-stage common mode filters. 
• Excellent attenuation performance for interference from 150KHz to 30MHz. 
• Items of which the current above 15A are designed with higher electric parameter value, specially suitable for UPS and other equipment because of their better filtering effect
  

Typical Applications of IEC Filters:

• IT, telecommunication equipment 
• Instruments and meters 
• Household small tools 
• Test and measurement equipment 
• Electronic equipment requiring connection of standard plug

Technical Data of Single Phase Filters:

1. Storage of IEC Inlet Filters: 

•  The EMI filters mustn't be left out in the heat of the sun or exposed to the rain, it should be stored in warehouse with good ventilation, surrounding temperature between -30℃ and +65℃ , the highest relative air humidity lower than 90%, and no corrosive liquid or gas.

2. Installation of IEC Filters:  

• IEC Inlet Filters should be installed at power input, and the line inside the chassis be as short as possible to reduce radiated interference. 
• Both input and output lines of Inverter filters neither be intersected nor be tied up by string.
• Make sure the mounting flange fully grounded, and keep the ground cable as short as possible if filters are connected to other equipment. 
• If the terminal is stud, please use two spanners to fasten the screw nut when connecting to avoid stud rotating and thus causing changes to the internal circuit and consequently leading to filters arcing, short circuit, broken down or the filtering effect worsened. 
• First use spanner1 to fix the screw nut near the metal case, then use spanner2 to tighten the screw nut in front( shown as Figure1), otherwise the terminals may be damaged. 
• Apply the same for the connection of other phases.

Requests for samples of any catalog item are available for engineering evaluation Free of Charge.

All EMI Filters are RoHS compliant and approvals held include CE, UL,cUL and TUV.

All quality control procedures are fully documented and available for review. FILTEMC is ISO 9001 compliant.